Skip to content

RDC & paramagnetic

Paramagnetic relaxation: PRE and paramagnetic CCR

Measure the relaxation a paramagnetic centre adds, from a diamagnetic and a paramagnetic sample, and fit the tensor to it.

A paramagnetic centre enhances the relaxation of nearby nuclei, and the extra rate falls away steeply with distance — which makes it one of the few NMR observables that reaches tens of ångströms and reports on sparsely populated, transient contacts that NOEs miss. The measurement is a difference between two samples, which is why it is easy to do badly: any processing or picking difference between them reads as structure.

These pipelines measure both samples the same way. A diamagnetic and a paramagnetic series are picked and fitted with the same settings, the rate each adds is computed per residue, and the result is carried straight into a paramagpy fit of the tensor against your structure. You can enter from spectra, from a peak list or from fitted intensities, and the fit that results is the same one the tensor-fitting task would run on a rate list you already had.

The cross-correlated variant does the same with η. The cross-correlated rate of each sample — diamagnetic and paramagnetic, each measured from its own component spectra — is fitted, and the tensor is fitted to the pair. Because η is far less sensitive to chemical exchange than R2, it is the safer route where exchange broadening would contaminate a conventional PRE.

What it needs

  • Diamagnetic and paramagnetic spectra, peak lists or fitted intensities
  • For paramagnetic CCR, each sample's cross-correlated component spectra
  • Structure with the metal site, and a starting tensor

What you get

  • Per-residue rate added by the paramagnetic centre
  • Δχ tensor fitted to it
  • Back-calculated rates and residuals

Enter wherever your data already is

This analysis runs as a full pipeline from spectra, or picks up from work you have already done — so nothing has to be repeated to get to the next step.

  • From spectra
  • From a peak list
  • From fitted intensities
Enter a pipeline wherever your data already isA four-stage pipeline runs left to right: spectra, peak picking, peak fitting, rate fitting. Three labelled entry points feed in from below — full starts at spectra, from-picking starts at peak fitting, and from-fitting starts at rate fitting — so work already done elsewhere does not have to be repeated.SpectraPeak pickingPeak fittingRate fittingfullfrom-pickingfrom-fitting

What does the work

  • ParaMagPy

    Open source, redistributed under its licenceGPL-3.0

    Tensor fitting to PRE and CCR rates

  • Cadence

    Built in-house

    Rate and η analysis

Related in RDC & paramagnetic