Relaxation & dynamics
Reduced spectral density mapping
Convert R1, R2 and NOE into spectral densities at three frequencies, without assuming a motional model.
Reduced spectral density mapping is the honest first look at relaxation data. It converts your three measured rates into J(0), J(ωN) and J(0.87ωH) by algebra alone — no correlation time, no order parameter, no model of the motion.
That restraint is the point. If your data are inconsistent, or exchange is inflating R2, it shows up here as a J(0) that cannot be reconciled, rather than being absorbed into a model-free fit as a plausible-looking Rex term. Run this before model-free, not instead of it.
You can map from raw spectra, from a peak list or from fitted intensities, or — when you already hold R1, R2 and NOE for one field — skip measurement and run the mapping directly on those stored rates.
What it needs
- R1, R2 and heteronuclear NOE for the same residues
- Field strength
What you get
- J(0), J(ωN) and J(0.87ωH) per residue with uncertainties
Enter wherever your data already is
This analysis runs as a full pipeline from spectra, or picks up from work you have already done — so nothing has to be repeated to get to the next step.
- From spectra
- From a peak list
- From fitted intensities
What does the work
Cadence
Built in-houseSpectral density calculation
relax
Open source, redistributed under its licenceGPL-3.0-or-laterReduced spectral density mapping
Related in Relaxation & dynamics
- R1 and R2 relaxation ratesFit per-residue longitudinal and transverse relaxation rates from a pseudo-3D delay series.
- Heteronuclear NOEMeasure the steady-state NOE from saturated and reference spectra — the most direct read on fast internal motion.
- Model-free analysisFit order parameters and internal correlation times, with model selection and a diffusion tensor that is estimated rather than assumed.
- Dynamics detectorsResolve motion into windows of timescale from any combination of relaxation experiments, without choosing a motional model first.